Hi,
I’m looking for a guide about how to configure a particular script run just once when a particular Windows endpoint start. My objective is avoid that a particular script failed because the endpoint was offline.
Regards,
Hi,
I’m looking for a guide about how to configure a particular script run just once when a particular Windows endpoint start. My objective is avoid that a particular script failed because the endpoint was offline.
Regards,
Hi there’s actually a condition that you can add in the monitors section of configuration templates. Just create a monitor name and after that just add the condition, on the conditions tab just select device status. From there you can specify if the amount of time that the device is online. On the general tab, select auto remediation on alert so that you can set the script that you want to run once the device is online. Once the monitor is created then you can add that to your current profile.