WIKI: How to configure auto fix procedure if alert triggered from any monitor ?

Step [1]. Go to section Configuration Templates>Profiles . Click profile applied to your devices.

Step [2]. Click ‘Monitoring’ tab . Click ‘Monitoring’ from the list where conditions to alert is configured.

Step [3]. Click Edit button to change general settings.

Step [4]. Click 'User Alert settings ’ and select ‘Alert’ you want to use.

Step [5]. Under ‘Auto Remediation on alert’ settings , Click ‘Run below procedure’ option and select fix procedure to be run upon alert.

Step [6]. Click ‘Save’ to apply changes . If alert triggers due to monitoring conditions then procedure mentioned in step [5] will run immediately .Technicians would be able to check procedure log in Devices>Click Device>‘Procedure logs’